A few odds and ends im looking for

[windshearalert]

If anyone has a set of tubular A arms, Im interested in picking up a set.
Would also like to upgrade to a pair of rear upper (Adj) and lower arms
Aftermarket driveshaft? Factory splines in Aluminum?

 

[278cikiller]

I have a after market drive shaft with a TH 400 yoke and the u-joints are for a stock rear end.$275.00 ship.

 

[tbone87]

ttaowner had some nice control arms in parts for sale if this helps..

Posted from the TurboBuick.Com mobile app

 

[toofastforyou]

I have a pair of H&R lower control arms (a little bit longer than stock) with greasable urethane bushings, provisions for sway bar, very nice condition: $150.

Claude.

 

[windshearalert]

Claude, these wont have any rub issues right? The longer ones eliminated that if I am correct?

 

[windshearalert]

I have a after market drive shaft with a TH 400 yoke and the u-joints are for a stock rear end.$275.00 ship.

Can I adapt that to work with a stock 200R4?

 

[toofastforyou]

The longer ones eliminated that if I am correct?

Yes, exactly. I just went to H&R's website and here's the listing for them;
"#0201 - Lower rear control arms, 78-87 GM G-body +1/4" CUSTOM LENGTH (adds 1.5 degrees pinion)" $249.

Claude.

 

[278cikiller]

Can I adapt that to work with a stock 200R4?

You would have to send it to a drive shaft shop and have them put a 200R4 yoke on the end and have re balance,this is a steel drive shaft.

 

[micknick1]

I have a set of metco upper arms

 

[windshearalert]

You would have to send it to a drive shaft shop and have them put a 200R4 yoke on the end and have re balance,this is a steel drive shaft.

I think the shipping would kill me on the shaft. let me know what you think on shipping to 72023

 

[278cikiller]

I will let you know,In a hour.

 

[278cikiller]

I think the shipping would kill me on the shaft. let me know what you think on shipping to 72023

I just back from the post office and i'ts $60.00 buck's to ship.And it will take 4 to 5 day's to get there.

 

[windshearalert]

thanks for all the help! I have my rear control arms covered and went with new bushings for front control arms. Going to start looking for an aluminum drive shaft to save a few pounds.

Thanks again fellas!