All you FAST gurus out there

[Wht87T]

Maybe someone can resolve this issue. The harness was wired up correctly but the only issue is with the wideband 02. The A/F ratio stays pegged at 9.19 and does not move at all either on the dashboard or in the datalogging page. Also on the VE page there is no 02 correction for each cell, which would probabally indicate that the 02 is inop. The box and wideband 02 are two days old. Here's some voltage numbers from the wideband with the ignition on.

UEGOS- 3.86
UEGOR- 2.59
UEGOV- .08

With the wideband unplugged

UEGOS 3.88
UEGOR- 4.98
UEGOV- .08 (no change)


-John

 

[Reggie West]

How do you have the dashboard set up?

Maybe you do not have Map KPA on the toolbar? That might be it.

Make sure the numbers on the WB O2 and the ECM match if they dont, it will not work.

The fact you are getting some sort of reading the UEGOS tables is good but just double check the numbers to see they match.

I had a car on the dyno ready to go and found out the O2 did not match up. We were just a little perturbed........

 

[Wht87T]

Reggie

Yes the 02 and the box match up they are both brand new.

 

[TurboDiverArt]

Re: Reggie

Originally posted by Wht87T
Yes the 02 and the box match up they are both brand new.

Jack Cotton is the man with a Fel Pro...

 

[86brick]

Re: Re: Reggie

Originally posted by TurboDiverArt
Jack Cotton is the man with a Fel Pro...

Cal Hartline is also the man with a Felpro......

 

[TurboDiverArt]

Re: Re: Re: Reggie

Originally posted by 86brick
Cal Hartline is also the man with a Felpro......

Yes absolutely!