Anyone need some big exhaust? SD area

[Squid4life]

Hey all, wanted to post this up in here as I really don't want to ship something this big. I took my big a$$ 3.5" (ID) single off and put on a 3" setup with high flow cat, new muffler, etc. I needed to quiet it down a little since I leave the house early and piss off all the neighbors.

Anyhow, it is a 3.5" ID (if not a bit bigger) mandrel bent exhaust that a buddy put together. I think he said he used exhaust off a Duramax, (stainless?) and a Magnaflow race bullet. I have run it for a while, but decided to change things up.

Just let me know if anyone is interested. Pics are below.

$50

 

[gnbooster87]

id love to get this off of you but im in the long beach area :frown:

 

[Squid4life]

Good enough reason for a drive down the coast?

(guess you can read this when you get back...)

 

[GNguy]

Ill take it if it can bolt right on....

 

[Mac in SD]

No tail pipe?

 

[Squid4life]

It bolts right on, but will need a hanger in the rear. The hanger was on the section I cut off. I might have a hanger for it too.

I had to use the "tailpipe" on another setup. The tailpipe didn't fit well and would hit the spring, so it is better off without it. It could use a turn down, but I actually liked the sound the way it is now turned down than with the "over the axle" as that part necked down to 3". (it resonated the entire RPM band.)

GNguy, you have dibs if you are interested. Where are you located? I am near Qualcomm. (Aero and 15)

 

[Squid4life]

TTT

GNguy you have first dibs, then someone who PM'ed, then Mac. GNguy, please let me know soon whether you want it or not. I really need to get it out of the garage to make room for my powder coating work. Thanks guys!

 

[Squid4life]

Gone!