- Joined
- Mar 1, 2013
- Messages
- 169
I was fortunate enough to find a local guy selling a AVC VDO GNX style gauge set and he happen to have the instructions. He was kind enough to share them with me as I need to do a few fixes on mine since the person that installed them did an “OK” job putting them in. I just replaced the sensors for mine since I did every sensor on the motor while installing a new Casper’s engine harness. Figure this should shake off any potential bugs down the road. I purchased a water Temp VDO 323-421 temperature sender and a
Oil psi VDO 360-003 pressure sender 80 PSI - 1/8-27 NPTF as that is what I pulled off my car. I don’t hoard information so instructions and photos are attached. I hope this helps someone.
Oil psi VDO 360-003 pressure sender 80 PSI - 1/8-27 NPTF as that is what I pulled off my car. I don’t hoard information so instructions and photos are attached. I hope this helps someone.
