B and M supercooler install

[Hammer231]

Just got my new B and M tranny cooler in from Jegs. It's the super cooler part# 70266. Unfortunately, it doesn't come with any installation hardware. Just wondering what all I need to get it hooked up and working with my freshly rebuilt tranny? Any suggestions or install tips?

 

[Lou Cipher]

The easiest way to intstall them is to use a couple hose clamps and a length of rubber hose. You can either put the cooler inline with the factory cooler or just bypass it altogether. Ive found that they work better inline but its up to you. You also may need a flaring tool and a tubing cutter depending on how you put it in. Good luck.

 

[Geoff87]

I use that cooler also.....

You will also need some 1/2" Male NPT to 3/8"? Barb adapters, since none are supplied.