Best way to wire line lock

[Chris McDade]

Do I need a switch with two or three prongs? What would be a good place to wire it to in the fuse box? Do I need just a power wire and a ground wire?

Thanks in advance

 

[John Larkin]

You just need a normally open momentary switch, two prong. Just a power wire from a key-on point is fine; there are a couple on the fuse box marked IGN. If you put a spade connector on your power wire, it will slide right in. Then run the power wire across the switch, hook it to one wire and ground the other. I wired a LED in with mine so I'd know it was on just for kicks.

 

[Chuck Leeper]

HOT WIRE TO SW??

The hot wire goes thru the switch and then back to the lock solenoid. The solenoid has a short ground wire on it that has to go to chassis grnd.. There should be a fuse in the kit.. Bout 5A, I think...Also a lite, that does not have to be used.