just finished installing pl. pluged laptop in to install drivers and everything worked out there... went to turn the car on and she wouldnt start. barely turns over and then click click click. the car ran fine before. i didnt hook up the analog piece to anything yet. any ideas? what could i have done wrong?
cae wont start after powerlogger install
- Thread starter Scarboy
- Start date
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
i sure hope youre right.... just be straight here, not using the other half of the pl( i\o dealy) wouldnt have any negitive effects would it? its just for boost monitoring and other added features right? im so new here it hurts... stay tuned for multiple "how do i tune" and "what do these numbers mean" type posts.
the PL does not affect the cranking of the engine. Thats all battery power.
That said, does the check engine light do its on-off-on cycle when you key on?
You can always remove the PL and try it again.
Not connecting the analog unit does not affect the operation of the unit.
Bob
That said, does the check engine light do its on-off-on cycle when you key on?
You can always remove the PL and try it again.
Not connecting the analog unit does not affect the operation of the unit.
Bob
also suffering from blinding rage.....any ideas how to deal with that?
I highly reccommend Zanax...........:biggrin: Oh and your battery is dead.
Thanks a lot for the reply Bob. its nice to know the man himself will take the time to answer even then simplest of problems. (battery was in fact dead) the first thing the power logger helped me figure out actually... bat volts were 9.0 with the key on. thanks again everyone
i will be heading to costco tomorrow to purchase zanax in bulk form for the rest of my tuning proccess.... so much knock it hurts MY head gasket
