Hey guys. I bought a new cam positioning sensor cap for the car, cause the original one has a big ol whole in the top and im afraid water will get in it., if not already. My question is, can I just remove the old sensor on top of the shaft and put the new one on? Or will It require anything else in order for it to get working?
Cam positioning sensor cap
- Thread starter BuickTV6
- Start date
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
Rough idle could be a lot of things...Like bad injs, vacuum leaks, IAC not set right, bad coil pack/ign module, etc...Doubt that it is the cam sensor cap causing your idle problem...But with a hole in the cap, it's not a bad idea to replace it 
Cam sensor cap
Once the engine is running the cam sensor could be unplugged and the engine will keep running. It is used to start the vehicle and give a reference for the fuel injection. It is possible to install the cam sensor 180* out, but you would have to lift the shaft up and install the gear out of time to do that. Hope this helps
Once the engine is running the cam sensor could be unplugged and the engine will keep running. It is used to start the vehicle and give a reference for the fuel injection. It is possible to install the cam sensor 180* out, but you would have to lift the shaft up and install the gear out of time to do that. Hope this helps
Similar threads
