converting to 3.5" maf...

[streetknight]

What all is needed besides the translator, MAF itself.

Piping and such. Make your own or is a kit available.

Or should I just go with a 3" and use the stock piping?

Thanks

 

[Dan Thompson]

3" was easiest for me.

4 hoses (each cut to length)

To get a smooth edge on the hoses:

slide the hose onto the MAF until the remainder of the hose extends beyond the end of the pipe.

using a sharp utility knife, cut the hose following the smooth edge of the end of the pipe.

if you think the hose might slip, just use a clamp to hold it in place.

2 clamps for the filter(if behind the headlight)
8 clamps for the rest of the system
2 exhaust pipe 45* elbows
1 MAF pipe

www.fullthrottlespeed.com has a good selection.

If you would like a picture send me your email address to

calpoly@cox.net

TIA

 

[TR Custom Parts]

We offer 3.5" MAF pipes in both chrome plated steel and aluminum.

You can attach a K&N filter to the end of the MAF sensor and keep the filter under the hood or go all the way and get one of our Big Mouth Cold Air kits.

Visit our website at www.buickgn.com