Crower Connecting Rods

[turbodave231]

This is a matched set of Crower rods I took out of a complete NASCAR S2 engine. The engine was built by H&E engines out of Virginia. The engine had a beautiful 3.580 stroke Crower crank (sold) and these connecting rods.

Here are the specs on the rods:

6.5" center to center length
.927 pin dia
2.3738 Big End housing diameter (standard Buick V6 size bearing)
1.006 Pin End width
.885 Big End width

I put one rod on my balance fixture and measured the following rod weights:
Total weight 763 g
BE weight 550.1 g
PE weight 213.2 g

These are "On-Center" and considered "Wide Journal" rods. They won't work in a stock engine without additional machine work.

Price: $500 shipped to most locations. Thanks for looking

 

[750H.P.V6]

H&E built nice engines. I had one at some point I think it ended up with Cheeseburger in Canada. They always used Crower stuff from what Kerry Novak told me. Super nice!

Good luck with the sale.

Neal

 

[Eticket]

some of the best rods you can buy... wish I could use them.

 

[turbodave231]

ttt

 

[9secGN]

I'd like to buy these rods. Please contact me with payment address.
Mark Jackson
cjackson@ohiolink.net
567-356-7615.

 

[turbodave231]

Sold!!

Thanks Mark!!