Custom Bob Borelli Sheetmetal Intake Manifold

[Monte88]

One-off aluminum sheetmetal intake manifold designed and built by Bob Borelli. The manifold was shown in Car Craft Magazine on a few occasions on a Duttweiler engine. All fabricated aluminum welded to a stock manifold base. Hundreds of hours of R+D into this piece, but unfortunately Bob couldn't find any of the design specs. 10.5" tall, so it should fit under a stock hood. Ports are 2"x1.1". I'd love to see this thing running on an engine again after 25yrs. Pricing is tough as this is a one of a kind piece, a custom sheetmetal intake today can be anywhere from 800-3000. $1000 shipped or best offer. Make an offer, its gotta go!

 

[jckcolarusso]

100 bucks

 

[Monte88]

100 bucks

Bidding has to start somewhere!

 

[TURBOTERRORV6]

800?

 

[Monte88]

800?

PM sent

 

[JayC]

If Bob built that shit, its fucking legit. Bob was one of the original mad scientists in this game.

 

[Monte88]

If Bob built that shit, its fucking legit. Bob was one of the original mad scientists in this game.

From his hands to mine.

 

[The_Six]

Anyone know what happened to this intake if it's still around