Engine Frame Mounts

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

hemi8

Goin Sideways
TurboBuick.Com Supporter!
Joined
Jun 6, 2001
Messages
1,015
Not the motor mounts, the frame mounts.
I have a stage 2 engine and HRParts motor mounts and the engine sits too high. In order to get the trans. at the proper driveline angle (3 degrees down) my driveshaft is about 1/8" from the floor right past the trans u-joint. So as it sits I cannot get a safety loop to fit. I plan to take a pair of stock frame mounts and shorten them about 3/4". Anyone else run into this?
Mike
 
Ahhh no, its the part the engine mounts bolt to, they are bolted to the frame, not sure what you would call them other than engine frame mounts.
Mike
 
Back
Top