Turbo6Smackdown
Well-Known Member
- Joined
- Dec 31, 2005
- Messages
- 6,110
I'm wondering, what options are there available to me, to connect these two together.
I'm looking to install a cutout, to a 2.5" dual system. These two here. Ebay item number 170351184404, and the sgg-50 pypes exhaust system from jegs/summit. The system has the typical cat back connector flange welded to it, and I'm guessing the hole is 2.5 inches in diameter, while the cutout has no flange, and is 3 inches in diameter. Here are my questions; If I get a flange welded onto the cutout, how will that quarter inch shelf, that's formed by connecting a 3" piece to a 2.5" piece, affect my flow/turbulence? And secondly,
if I yank the flange off of the exhaust system, are there any reducers available to bridge that gap?
I'm looking to install a cutout, to a 2.5" dual system. These two here. Ebay item number 170351184404, and the sgg-50 pypes exhaust system from jegs/summit. The system has the typical cat back connector flange welded to it, and I'm guessing the hole is 2.5 inches in diameter, while the cutout has no flange, and is 3 inches in diameter. Here are my questions; If I get a flange welded onto the cutout, how will that quarter inch shelf, that's formed by connecting a 3" piece to a 2.5" piece, affect my flow/turbulence? And secondly,
if I yank the flange off of the exhaust system, are there any reducers available to bridge that gap?