Fuel rail

[boosted-para]

Hello All,

Couple of questions I am being thrown off by. I am trying to install fuel pressure gauge, but

1. My fuel rail doesn't have a Schrader valve, instead it's been replaced with a small bolt? I didn't know the valve came out, so now what?

2. Some how some way I have 2more rails in the garage, but they are uneven, by that I mean if I lay one side on the bench, the other side is in the air. These belong to 86/87 car?

Any ideas how to attach the sending unit for fpg? Obviously I could drill it out, but the rail is installed in the car, I don't know how that escaped my attention when I installed, but it did.

Jay

 

[NorCalTurbos]

Jay I have an extra fuel rail here for our cars should be ok if you need it I'll ship it let me know, you can have it

 

[boosted-para]

Thanks Cory. Yeah idk how I ended with a bolt in it? I may trade u the exhaust for it. U interested

 

[6 to go]

The schrader valve faces forward toward the radiator on the 86/87 and is 90* to the fuel rail on the 84/85.
The 86/87 rail will work on the 84/85 but is very close to the coil pack. I have an 86/87 rail on one of my HA cars,
though. No problems unless I want to hook up a FP gauge to it.

 

[boosted-para]

Hmm wonder what these rails go to? I will post a pic of it later. They are odd. Like I said They are offset. If I was to put it on our cars, I could put pass side injectors on but there wud b 1/2 gap at number 5 inj and about 1 1/2 at num 1. Wierd. I have a bad memory.
As far as the bolt in the rail? Do not y someone wud have done that either

 

[NorCalTurbos]

Thanks Cory. Yeah idk how I ended with a bolt in it? I may trade u the exhaust for it. U interested

Sure we can work something out idk how much it's worth but we will figure out something