Help?

[SS502]

Took car out for test drive with new razor single nozzle/3bar. During install put in the powerlogger and 2.2 scanmaster chip. Did the reflash and upgrade per instructions. Scanmaster on key on reads SM 2.2 PL 3.0
Powerlogger hooked to laptop win 7 all good. New alky TT chip. My issue is the boost. Doesn't read on powerlogger or scanmaster.
Attached the .dat file.. look to frame 2550 for first time into boost..got around 16lbs on pod gage, but nothing on PL or SC so got out of it.
Thanks in advance, Brad

 

[SS502]

Posted this in the General section as well and getting some help, so if a Mod would like to delete this post it's fine by me.
Thanks guys.

 

[missin' 2]

Do you have a wire going to the powerlogger input board from the 3 bar signal wire?