Injector Harness

[LikeMy6]

I was looking over caspers website and ran across a Injector harness w/t 14 ga. wires that was listed for HP applications using low impedence injectors. Anyone using this and is it really nessary? Ive never heard or seen any problems w/t the factory harness just wondering if this would add any legitemate benefit!

 

[LikeMy6]

No one has a opinion on this,just trying to justify if its needed over a stock harness!
TTT

 

[TurboTR]

re:

Well the harness wire lengths are so short really that it's likely a very minor difference, as in probably hard to even measure. OTOH, if you are replacing the harness anyway then it's not a bad idea IMO. I have one

TurboTR

 

[9SECVSIX]

I up graded to the 14 ga Caspers unit several yrs ago when I installed the Fel-Pro, I needed a new harness anyway, nice piece IMO.

9secvsix

 

[HighPSI]

Same here. I needed a new harness so upgraded to the 14 guage unit