Jackie grabos
Member
- Joined
- Feb 2, 2011
- Messages
- 125
ok, did not read scan master install correctly. I hooked everything up, but used a fuse tap and hooked red wire to ecm/ign on fuse box. the car started and scan master was reading. after about a minute looked down and noticed oil pressure gauge was not lit or working and boost gauge and temp gauge lights not working. I jiggled the fuse tap and the car died. now I understand it was meant to be plugged into ign terminal on left side of fuse box. the st belt acc fuse was blown. I unhooked scan master and replaced the fuse. I am getting power to all fuses in fuse box now. when the key is initially turned on dash lights, sunroof etc work. the car will turn over but not start. i'm guessing I blew the ecm? is there anyway to test this. really bummed, just finished paying the car off and was looking forward to finally trying to get the car tuned. also scan master was showing low 02 sensor readings, not sure if this is normal at start up. any help appreciated for mechanically challenged in Houston.
