Insulating alky tank

[gusszgs]

I there a insulation blanket we can purchase for the alky/coolent thank on a Razors kit? Possible one like on the TTA'S
I've noticed since I installed the RJC 3" DP that things are getting a little too toasty around that tank for my liking.
Searched around but come up empty. TIA

 

[Scott87]

Consider heatwrapping the downpipe?

 

[gusszgs]

I did, but was concerned regarding the wrap being a moisture trap. But, the DP is stainless, so that should not be a problem I wouldn't think. Thanks Scott

 

[Eazy-E]

i actually remember reading on here that the alky works better with the heat?

 

[Eazy-E]

http://www.turbobuick.com/forums/al...332485-alky-injection-when-cold-air-cold.html
post #3 from the man himself

 

[gusszgs]

Hummm.......interesting stuff. Thank you

 

[Scott87]

I suppose another option to reflect some of the heat you could use duct tape. The aluminum stuff used to do seems on forced hot air heating.

By the time you would be done with it the tank would look as if you covered it in dynamat. This wouldn't insulate in so much as it would reflect any potential heat at the tank.