HEY GUYS THE STOCK PARTS ARE OFF MY 87 GN WITH ONLY 58K ON IT ALL OTHER PARTS ARE AS STATED. Will post pics tomorrow, prices do not include shipping or PayPal (3%)
Stock throttle body and plenum $80 obo (still on car doesn’t include electrical)
Stock intake never been off car, pulling it off tomorrow (no known damage) $200
Or as a package deal T/B, plenum, and intake $250
Ported Intake (was told it was ported by Champion and painted silver but paint is starting to lift in some places) $300
TE44 minimal up and down play, no in and out play less than 3K miles $375
Stock MAF (small cut out to fit sensor when drilled in K&N) $70
PowerMaster work still on car but a starting to make noise (i went to vacuum) $180
Front RT & LT wheel well moudings few dings driver condition $50
14” K&N air filter with sensor and inlet tube with usual scratches (K&N has duct tape where sensor is install like we all have seen) $125
Stock heads $200
translator+ lt1 MAF sensor(screens removed from sensor) $160
bought of board member recently lt1 MAF has some scratches and holes in translator (hold down cover) are strip out works fine but im a little OCD
Stock throttle body and plenum $80 obo (still on car doesn’t include electrical)
Stock intake never been off car, pulling it off tomorrow (no known damage) $200
Or as a package deal T/B, plenum, and intake $250
Ported Intake (was told it was ported by Champion and painted silver but paint is starting to lift in some places) $300
TE44 minimal up and down play, no in and out play less than 3K miles $375
Stock MAF (small cut out to fit sensor when drilled in K&N) $70
PowerMaster work still on car but a starting to make noise (i went to vacuum) $180
Front RT & LT wheel well moudings few dings driver condition $50
14” K&N air filter with sensor and inlet tube with usual scratches (K&N has duct tape where sensor is install like we all have seen) $125
Stock heads $200
translator+ lt1 MAF sensor(screens removed from sensor) $160
bought of board member recently lt1 MAF has some scratches and holes in translator (hold down cover) are strip out works fine but im a little OCD
