ISAC boost control solenoid

[juan89]

Hello,

I need to order the solenoid to control boost, using the ISAC controller.
Does anyone know the part number and where to buy?

Regards,
Juan

 

[aminga]

I use this one


Valve, Solenoid, 1/8 In - Solenoid Air Control Valves - Valves - 6JJ52 : Grainger Industrial Supply

Muffler, Exhaust, 1/8 In NPT, 7/16 In Hex - Pneumatic Muffler - Pneumatic System Components - 1A325 : Grainger Industrial Supply

I did replace the fittings on it with 1/8 NPT pushlocs

 

[juan89]

Thanks,
Juan

 

[aminga]

You can use the stock solenoid but it's range is limited

 

[missin' 2]

How are you using it, bleeder or blocker. I'm not sure what to set mine up as. I plumbed it as follows. 1 is in from the compressor housing 2 is out to the wastegate and 3 is exhaust. I just took out my RJC manual controller and replaced it with the IR solenoid. Thanks

 

[aminga]

How are you using it, bleeder or blocker. I'm not sure what to set mine up as. I plumbed it as follows. 1 is in from the compressor housing 2 is out to the wastegate and 3 is exhaust. I just took out my RJC manual controller and replaced it with the IR solenoid. Thanks

Mine configured as a blocker.

 

[missin' 2]

Ok. I'm still having some problems tuning this controller. I think I'm going to take a step back and start over. Try and put some logic into it.