looking for a BGC downpipe to match this elbow

[Turbo V6 231]

here is the elbow that BGC made, it attaches to a 3" stainless downpipe, I need the downpipe, if anyone has one let me know
send me a PM
thanks Brian

 

[Turbo V6 231]

Ttt

 

[Turbo V6 231]

TTT

 

[Turbo V6 231]

TTT

 

[Jay J]

I may still have one--will have to check the storage locker...

 

[Turbo V6 231]

Ok,thx just PM me when you get time,and send me a picture
Thanks Brian

 

[jlat]

hello; I don't have a DP for you but if you ask around I'd say (looking for a DP to match a series 2 BGC elbow). The first was a weilded job and not as nice. I don't know if the same DP would work with either elbow.
good hunting
IBBY

 

[Turbo V6 231]

Still looking, it's mandrel bent stainless
Thx

 

[Turbo V6 231]

TTT

 

[jhanson1750]

I think I still have one I picked up years ago floating around in the garage! I thought I could find the elbow but never did. I will check this afternoon. If so I will post some pics and measurements.

 

[Turbo V6 231]

Thx I just pm'ed you with my email address gif pictures thx Brian

 

[Turbo V6 231]

Any luck with those pictures?

 

[jhanson1750]

 

[Turbo V6 231]

Pm'ed you

 

[jhanson1750]

Sorry for the lag time, got tied up with work this weekend. I was told this was a BGC down pipe when I got it. There is a piece of pipe that was welded to the end (in pic) but otherwise it's a nice piece. I tried to find the elbow that went to it when I got it, but never found one. I almost cut it up several times but talked myself out of it. I tried to show the bolt pattern it's 4.25"(4-1/4"). Let me know if it's what you need and we can work something out. I will PM you my cell #. Jon

 

[Turbo V6 231]

i got one thanks for all the help