Low Alky Light??

[JUSTAV6]

I was going down the road and put it to the floor and I had Kr, Well I stoped and hit the test button and noting, And I did not see no low alky light come on at all, Checked the tank and it was dry And I checked all the wireing and still no low fuel light, So whats up with this,
Thanks For Any And All The Help,
Seneca Lafler,

 

[salvageV6]

There is a float inside the bottle that activates the swich, make sure it rides freely on the tube and floats in the alky.

Fill the bottle about half way and check it. Hopefully the light will go out.

PS: M.O. is in the mail for the Percy's.

 

[JUSTAV6]

Originally posted by salvageV6
There is a float inside the bottle that activates the swich, make sure it rides freely on the tube and floats in the alky.

Fill the bottle about half way and check it. Hopefully the light will go out.

PS: M.O. is in the mail for the Percy's.

Yes I checked the float and it moves freely, And the light it not on and wont come on, I mat have cut the wire, I will check that later today,
And I will Send ya some mail wene I get your money order,,
Thanks For The Reply,
Seneca Lafler,

 

[salvageV6]

Next test that I would do would be to unplug the wiring from the bottle and use an ohmeter on the two terminals with no alky. in the tank.

Should get a 0 ohm or very low ohm reading on the X1 scale.

Filled it should go to an open circuit or very high ohms reading.

Remember no wiring or power to the bottle when you do this test.

You will be testing the float switch itself at the bottle.

Almost time to be contacting Steve C. about it....

 

[JUSTAV6]

Originally posted by salvageV6
Next test that I would do would be to unplug the wiring from the bottle and use an ohmeter on the two terminals with no alky. in the tank.

Should get a 0 ohm or very low ohm reading on the X1 scale.

Filled it should go to an open circuit or very high ohms reading.

Remember no wiring or power to the bottle when you do this test.

You will be testing the float switch itself at the bottle.

Almost time to be contacting Steve C. about it....

Well bad news for me, I pulled the float out and a wire was pulled out some how, I will see if Steve can fix it for me, Or how much a new float + wireing would cost,
Thanks For The Info,
Seneca Lafler,