You can type here any text you want

Need a little turbo help

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

mred355

Member
Joined
Oct 19, 2004
Messages
113
Hi Guys. I have an 87 GN. I have cleaned the throttle body and IAC and set the IAC to 16 the Tps to .40 on idle and 4.6 WOT. The fuel pressure is set to 43 # with Vac. unhooked. The boost set to 18 # at WOT. I have a turbo tweek chip burned for the set-up and I have the 1-2 and 3-4 timing retarded 3 degrees. It runs great; but the retard during the 2-3 shift is a little high. The scanmaster reads 820 Mv. and 4 deg. retard at the shift. Not sure what to adjust to correct this or is it normal for this set-up? Any feedback would be appreciated. Thanx in advance. Ed
 
Turn the boost down a pound or two and see if the knock goes away.
 
Hi Shawn. I turned the boost down to 16#. Took two passes and at 2-3 shift I got 824 Mv and .7 R then 800Mv. and 0 R Should I leave it or whats next?
 
Yes I would leave it right where it is what octane are you running??
 
Don't know what mods you have, but your options are:
1. Leave it alone with 16 psi and 0 KR
2. Run race gas $$$
3. Add an Alky kit
4. Convert fuel system to E85
If your fuel system is stock, you need to address that before doing anything.
 
Hey it runs great. I think I will quit while i'm ahead. Thanks for all the help. Ed
 
16 #s is about the max you will get on pump gas. I think I had one running 17 on 94 ultra before Sunoco got rid of it. These days I run 100 octane unleaded and 22 #s
 
I added Razor's methanol kit to my whip years ago, best thing I did by a long shot. Mine is more street than strip, so the alky saves my wallet because I don't need race gas to run 23 PSI.
 
Alky is the way to go if your gonna run 92 octane pump gas . You can see my upgrades in my signature and I'm sitting on 25 lbs of boost and will turn higher with no worries . All because of Julio at Alky Control .
 
Back
Top