Need help! Who made this boost controller?

[scot w.]

Does anyone here know who made this boost controller? and if so would anyone have some kinda manual for this thing? I got it for nothing and would like to at least try it.. Scot w.

 

[V6 Beast]

I think ATR used to sell them.. pretty simple setup.. Do you have a question?


Sully

 

[scot w.]

I think ATR used to sell them.. pretty simple setup.. Do you have a question?


Sully

Yea, Where do you set the actuator rod when installing this? How well do they work? Do they help with spool up? Thanks ,Scot w.

 

[V6 Beast]

Yea, Where do you set the actuator rod when installing this? How well do they work? Do they help with spool up? Thanks ,Scot w.

I would set my rod so that when the valve was all the way closed you got about 16-17 psi. That way you can open the valve to go on up. Works as good as any bleeder type valve. Won't make much change on spoolup. One of the ones that have hte spring loaded ball bearing may help with spoolup.

HTH

Sully

 

[scot w.]

I think ATR used to sell them.. pretty simple setup.. Do you have a question?


Sully

Does anyone have access to the instructions or directions on where to set the actuator rod at?

 

[V6 Beast]

There are no instructions for that. They aren't even for use with adjustable rod really. You want to set the rod so that with the valve all the way closed you have the lowest amount of boost you want to run. 14,15,16 whatever you want for street gas. That way you will have the most control on raising the boost. The more you open the valve the more boost you will get. Pretty simple.


S.

 

[scot w.]

There are no instructions for that. They aren't even for use with adjustable rod really. You want to set the rod so that with the valve all the way closed you have the lowest amount of boost you want to run. 14,15,16 whatever you want for street gas. That way you will have the most control on raising the boost. The more you open the valve the more boost you will get. Pretty simple.


S.

Okay, Thank you!