Need torque spec for bolts that fasten plenum to intake

[t-topflyer]

I need to know what to torque the bolts to that fasten the stock plenum to the intake manifold. If you can help me out, please let me know. Thanks in advance.

 

[jpwalt1987]

I wouldnt go more than about 15 ft/lbs. So long as they are snug you will be ok. Any tighter and you will probably start pulling threads out of the intake. Hope this helps

 

[DCVING 6]

Three finger tight with a 1/4" ratchet.

 

[JM_in_TX]

I wouldn't go over 12 ft/lbs, mine started to strip above that. The manifold must be fairly soft. I will probably have to re-tap mine if I take the plenum off again.

 

[scottk]

just use common sense its aluminum!thats what i did !no problems