No PCV, worse case scenerio?

[qwks6]

I had all kinds of pcv problems before my rebuild. I actually ended up with bad rings around my pistons, but that's another story! Here was my pcv thread, with a pic of the setup I went with. I also used one of those little check valves from us plastic corp...

http://www.turbobuick.com/forums/general-turbo-buick-tech/260876-oil-after-pcv-hose-blowoff.html

Hope that info helps...

 

[The_Six]

I have Kirbans inline check valve also. Have'nt gotten around to installing it yet. I'll be pulling the intake soon. I'll install it then.

If your removing the intake why keep the factory vacuum block get rid of it and put one under the coil pack out of site and then your PVC wont be sending oil threw the TB any more.

 

[Scott87]

If your removing the intake why keep the factory vacuum block get rid of it and put one under the coil pack out of site and then your PVC wont be sending oil threw the TB any more.

Got pics of that install sounds interesting.

 

[The_Six]

Dont have the engine back in yet but picks of the parts and some of how I did it can be seen here http://www.turbobuick.com/forums/engine-tech/324891-pcv-vacumn.html I got the vacuum block from ebay and I bought all hard lines from granger had to buy 100ft of the stuff but its enough to replace every line with hard lines.

 

[vacuum 6]

I had all kinds of pcv problems before my rebuild. I actually ended up with bad rings around my pistons, but that's another story! Here was my pcv thread, with a pic of the setup I went with. I also used one of those little check valves from us plastic corp...

http://www.turbobuick.com/forums/general-turbo-buick-tech/260876-oil-after-pcv-hose-blowoff.html

Hope that info helps...

You have a PM.