yall member I've been having them hard cold start problems? well now I have a no start problem. so Ive checked= no spark on either side of coil pack, have fuel pressure, getting 12v to module, cam sensor is sending signal. what do I check next? car cranked earlier today.
no spark
- Thread starter gsbuick65
- Start date
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
one_bad_gn
New Member
- Joined
- Nov 9, 2007
- Messages
- 44
Have your ignition module tested. AutoZone can do this for you.
- Joined
- Feb 18, 2006
- Messages
- 10,083
Crank sensor. 
Blown&Injected
Active Member
- Joined
- May 31, 2001
- Messages
- 3,721
I would pull the coil - leave the module in place.
Use a test light to see if the module is sending power to the coil - light should pulse when cranking the engine. If that is good, check out the coil and wires - if it has been going down hill slowly I'm bettin' coil.
Use a test light to see if the module is sending power to the coil - light should pulse when cranking the engine. If that is good, check out the coil and wires - if it has been going down hill slowly I'm bettin' coil.
87granny
Active Member
- Joined
- May 17, 2005
- Messages
- 1,547
too bad your not closer have a module that is bad but 4 cylinders fire could just put it in to test
