oil pressure switch wires

[jim0207]

The female oil pressure switch wire connector was damaged. The wires are ok but the plastic has become distorted beyond repair, so I removed all of the remaining plastic. I think shrink wrap will work on the female spades and then reattach them to the switch. My question is what color goes were? As I look at the switch the A terminal is left, or 9 o'clock, B is at the bottom center location and C is to it's right, or 3 o'clock.

 

[dynoman]

Caspers has the replacement connector with pig tail part #108092 , $8.95

 

[earlbrown]

Page 24 and 17... Looks like Pink/Black is "A" (power feed), Gray is "C" (output to fuel pump),

"B" (tan) should show ground at rest and become open at 4PSI for the"oil" idiot light.

 

[hawkfan]

Caspers has the replacement connector with pig tail part #108092 , $8.95

This is what I bought. The old connector crumbled like a piece of cake when I tried to take it off of the sensor.

 

[dynoman]

I knew they had the connector cause I need one myself !!

 

[jim0207]

Thanks everyone. This club is the greatest.

 

[klmnla]

Thanks everyone. This club is the greatest.

After I replaced my connector, I wrapped in in some heat shield products velcro heat shield. I cut it to length, and used it to wrap other lines etc near the hot areas.