Pillar mount FP Guage ???

[T-Type Mike]

Guys I just picked up my new FP guage. I want to mount it inside on my pillar. The Autometer kit has everything, but I would like a clean install. What I will be looking to do is mount the sender away from the rail. Thus needing 90degree bend off the rail itself, then line to fender. Would anyone have a part number of a 90 deg. fitting??? Also how are you guys mounting your guage?? Anything that would be easier is always better!! TIA, Mike

 

[Tow Man]

Here's the fitting;

http://secure.johnsperformance.com/...8812.23677*K46kw&next=10&product=Fuel-Systems


Bottom of the page!

 

[dconnor]

Since you didn't mention it, I'm hoping you are going to run an electric guage or an isolator on it & NOT have a line full of fuel in your passenger compartment!!!!

Doug C.

 

[T-Type Mike]

Thanks for your replies guys, I was hoping I may be able to pick the part up here, I'm in Canada, But otherwise I will go to John's, I know there a class act. I am definately running the electric guage. Safety first Thanks again, Mike

 

[ONLYA6]

Mike, I used a steel braided line from Cottons Performance. It came with a FP gauge on the end of it, but I took that off and attached the sender to that. The braided line is actually long enough that it's all the way up against the fire wall so the sender is completely out of sight. On the inside I "hollowed" out the drivers side kick panel and mounted the electronics for the gauge on the inside of it with double sided tape. I then mounted the gauge on the A-pillar with a Lotek 3 gauge pod. If you need any help let me know. ONLYA6@aol.com

Jacob