random acts of fabrication

[slimtastic]

custom main switch panel i made for my datsun 280 racecar. 1/8 sheet, tig welded,50 amp relays lining the top.

crossmember for mounting a th350 into my 280

one off intercooler....they didnt make cores this big so i had to stack two 12'' tall units. the endtanks have air splitters built in to funnel airflow down to the bottom half.

overkill, its not just a term...its a state of mind. in retrospect with the weight if this unit, i should have gone a/w

ive got other stuff i built that ill post up later on...lmk what ya think

Image - TinyPic - Free Image Hosting, Photo Sharing & Video Hosting

 

[slimtastic]

3 inch downpipe almost finished. v-band connections on both ends

4 inch cold air intake, mandrel bent aluminum, 14inch k&n filter

"cold air" setup mounted in vehicle

 

[YouLikeThat]

Damn nice welds.

 

[V6RACER]

Looks good

 

[DailyDrifter]

How close is the 280z chassie to the 240sx chassie? Nice welds.

 

[slimtastic]

How close is the 280z chassie to the 240sx chassie? Nice welds.

the 280z is roughly similar to a 260Z and a 240Z but even then the 240 has a stubframe whilst the 280 runs full length.

a 240sx is a completely different car.

 

[Super6]

welds

Very nice welds. i hope mine look that good someday............Bob