Razor alky Question.

[278cikiller]

I have a old style Razor Alky System,i have a few wiring questions to ask, frist is i have a creem coulor wire that comes from the tank were does that wire tie into, and second i have a green and purple wire that comes from the the main box were does these two wires wire in to if some one can help that would great.:biggrin:

 

[278cikiller]

I have a old style Razor Alky System,i have a few wiring questions to ask, frist is i have a creem coulor wire that comes from the tank were does that wire tie into, and second i have a green and purple wire that comes from the the main box were does these two wires wire in to if some one can help that would great.:biggrin:

Hey by the way guys thanks for all your help 39 hits wow.

 

[Razor]

Tan wire from tank is for the low level. You should have a RED LED for the low level. It will have a red wire, and a tan wire. Red wire goes to +12 and tan wire goes to tan wire from tank.

Green is MAP input from the 3 bar.

Purple is a reduction input. Dont hook up anything to this until alcohol system is working 100%. It is tied into your transbrake circuit if you run one.

 

[turbogray]

Green is connected to map sensor
Violet is the negative trigger input terminal for pump speed reduction.
Tan is the low level warning tank light

 

[turbogray]

Damn too slow Razor beat me , Jajaja

 

[Razor]

Damn too slow Razor beat me , Jajaja

You sir have been Tree'd

 

[turbogray]

You sir have been Tree'd

I'll work on my R/T Jaja