Rear seal and bushing replacement

[Beamer]

Just picked up a turbo car a few days ago. I knew it had a leak at the rear seal. Went to replace the seal today after dropping the pan and replacing the filter, and realize that I need the bushing replaced and I need another yoke for the shaft.

How do I remove the bushing? Is there a special tool to use? If so, where could I get one at? Is this something I can do in a garage, or should I take it to a tranny shop? When I purchased the seal, I got the set with a bushing also, but it does not seem to want to come out - easily at least.

Also, where is a good source to get a new yoke at?

Thanks all,
Mike

 

[Nordbert]

GM tail bushing remover/installer for 200-4r,4l60,th350

Check out:
Installer-Remover, Extension Housing Busing, Output Shaft Support Fixture, GM (Atec: model T-0160-A)

 

[Nordbert]

Driveshaft yoke info

Check out:Dennys Driveshaft Slip Yoke selection for Transmission and 4x4 Transfer Case applications