Slightly Bent Turbine blade
- Thread starter MCH86GN
- Start date
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
- Joined
- May 28, 2001
- Messages
- 16,605
repair/rebalance... maybe.
Most likely replace.
Most likely replace.
Chuck,
I am going to post a picture and see if anyone has a recommendation. If I am required to replace, I don't that I want to go that route. I think a replacement would probably be close to what the turbo is worth. In addition, this a 6265 that I bought in 2014 and installed it in my car in 2017 and did not ever do a WOT pull with the turbo. What a shame.
- Joined
- Jun 18, 2001
- Messages
- 2,162
Replace. These things spin at nearly 100,000 RPM. Any displacement of mass will imbalance it and it'll tear up the bearing and then the housing.
GNVYUS 1
Well-Known Member
- Joined
- Dec 15, 2002
- Messages
- 4,342
There's a guy on the Dsm boards
Justin Whitesell
Pm me for his email
He's rebuilt 2 or 3 of my old school turbos, way way cheaper and the guys no hobbiest, can balance etc. Replaced turbine wheels and a compressor etc.
I've used him for at least 5 years now, hard to keep track but he's legit.
I had his rebuilt 62/65 on my Talon for at least 20k miles without issue before I swapped to 6062 Gen BB after a head gasket issue on my Talon.
Justin Whitesell
Pm me for his email
He's rebuilt 2 or 3 of my old school turbos, way way cheaper and the guys no hobbiest, can balance etc. Replaced turbine wheels and a compressor etc.
I've used him for at least 5 years now, hard to keep track but he's legit.
I had his rebuilt 62/65 on my Talon for at least 20k miles without issue before I swapped to 6062 Gen BB after a head gasket issue on my Talon.
Similar threads
- Sticky
- Sticky
