TPS fault code, XFI

[3.8vsix]

Not sure if I have my tps adjusted right. Every time I go WOT my service engine soon light comes on. I recorded a run and it shows my tps going to 100%. The line on the graph goes out the top of screen. The car runs great
otherwise. My Tps is at 2 at idle. The raw voltage is .94 at 0% and 4.94 at 100%. I have my tps calibrated poperly. What else do I need to adjust.

 

[HighPSI]

Travis,
Go to "View/System Config/Sensor Cal/TPS Sensor" and make sure that the x-axis scaling is correct. If you have any questions, feel free to call me.
If the scaling is correct, then you may need to adjust the TPS sensor so it doesn't read so high at WOT.

 

[3.8vsix]

Yes it is scaled correct. Is it ok for the tps to read 0 at idle? It is at 2 now at idle. Thanks!!!