TTA front vents in hood

[TT/Ameasap]

How do you remove these things? Is there a special tool to get the second nut off? The hole is too small to get the correct socket on the nut. The outside ones came off easily.


TIA
Bo

 

[davege]

The nuts holding them in are sheet metal and have about a 1/16 inch edge on them. I use needle nose plyers to grab the edge through the hole and gently twist them off. Be carefull not loose them. Two nuts hold them in place. Once they have been removed the grills pop right out.

- Dave

 

[Jan Larsson]

As Dave says needle nose plyers works fine but takes some patience to get the nut off. Also be careful when you put them back not to overtighten the nuts as the cut into the plastic.

 

[TT/Ameasap]

Thanks guys.

Bo