Jan Larsson
Active Member
- Joined
- Nov 22, 2001
- Messages
- 2,151
Pre the title. Can't seem to find goo pictures of where this wire is routed.
In the first picture you see which wire I'm on about, second picture shows the P-clips that holds the positive and negative "thick" wires do the thinner positive run through on of these as well?
Where does the thin wire go down behined the engine oil-cooler setup or above and then down? I know it runs in the plastic channel at the bottom of the held in place by the studs for the IC brackets.
Where does the thin wire route from the bottom on the driver side up to the bolt on the alternator? Just straight up behind/between the tensioner and alternator or somewhere else?
Any help or photos mych appreciated so I can get this together and start my engine for the first time after the rebuild.
In the first picture you see which wire I'm on about, second picture shows the P-clips that holds the positive and negative "thick" wires do the thinner positive run through on of these as well?
Where does the thin wire go down behined the engine oil-cooler setup or above and then down? I know it runs in the plastic channel at the bottom of the held in place by the studs for the IC brackets.
Where does the thin wire route from the bottom on the driver side up to the bolt on the alternator? Just straight up behind/between the tensioner and alternator or somewhere else?
Any help or photos mych appreciated so I can get this together and start my engine for the first time after the rebuild.
