Turbo Trans Am parts

[dsmith4994]

1989 TT/A wiring harness from the computer to engine and all the wiring harness under the dash. Perfect for a GTA turbo 6 conversion which will allow you to use the 89 GTA dash. This includes the impossible to find VSS (vehicle speed sensor) and the sensors that are still attached to the firewall and fender brackets, This has the vats security system stuff in it. I dont have the vats keyswitch. $900.00

1989 turbo trans am headers and crossover pipe. 3 out of 4 of the crossover pipe studs are broken off and need to be tapped out. $600.00

1989 TT/A EGR solenoid bracket only no solenoid. $125.00

alot of misc other little TT/A specific drive train parts email me at dsmith4994@aol.com with any questions

 

[dsmith4994]

more TT/A parts

The previously posted parts are still for sale
I have more 1989 TT/A parts for sale:
used AC lines w/ TT/A sticker on it for $200.00
I also found the water cooled oil setup with the oil pressure relay switch that goes with the stock wiring harness and i also have the vapor canister with the correct plug to match the wiring for the person who buys the wiring for another $100.00 email me at dsmith4994@aol.com

 

[dsmith4994]

Found more parts

The rest of the parts are all still for sale but i just found the 89 tt/a small lower bracket that supports the air conditioner compressor in the back and goes to the header........40.00 plus shipping
radiator hold down top cover.......50.00 plus shipping
I am entertaining offers on a 32k mile 89 tt/a shortblock and bare heads that i might put up for sale soon......email me at dsmith4994@aol.com

 

[dsmith4994]

found more parts

i found a few more parts
tt/a specific gas tank $200.00 pickup only
sending unit $150.00
original fuel pump $40.00

 

[88ZNX]

Im looking for the heat shield that fits on the over flow tank, if you have one please call me at 888 961 3368 thanks Alan.

 

[dsmith4994]

re: overflow blanket

I sold that item to msando (board member) sorry :frown:

 

[Jan Larsson]

email me (jan_l@rsson.com) about the alternator rear brackets you have. Also do you have the small bracket/s holding the fuel line to the driver side valve cover (held in place by the front acorn nut) ?

 

[Jicaju]

What will you take for the oil cooler setup. Call me 336-682-3232 or I'll call you if you leave number. Thanks Michael

 

[sdteb]

pics

of the headers please

 

[dsmith4994]

Re: parts still available

I also have the drive shaft and everything listed above and more email me at dsmith4994@aol.com