TurboTweak question

[86BGN]

I am trying to adjust some of the programmable features on Eric’s chip. The instructions say to select a parameter, turn key on/engine off, LV8 on my scan tool will now show which parameter I will be adjusting. I don't see a LV8 on my scan master anywhere?

Any help would be appreciated!

 

[pacecarta]

theres an LV mode on Sm that reads 0 with key on (not started )

if you move the ac selector it will advance to 1 (1-2nd timing) then 2 (3-4th timing) then back to 0 (WOT fueling )

once you see the mode you want turn off the a/c switch , then disconnect the iat sensor by the air cleaner (i rigged a switch to the console) , then put SM in BLM mode and then by turning the a/c to on you can watch the numberon the SM rise up to 140 then back around , shut off the ac when you get to the number you want , then reconnect the iat sensor and turn off the key ,
if you want to program other perameters just repeat what you did

now when you turn the key to the on position the same way you programmed you can reveiw the settings ,just dont unplug the iat

 

[pacecarta]

correction to above post
the LV8 on SM is displayed as L8 ,

 

[86BGN]

Thanks for the help! I will look for L8 on the scan master.