Ram Air TTA
New Member
- Joined
- Jul 21, 2002
- Messages
- 23
Yesterday I started my car it ran fine, I ran upstairs for about three minutes
when I came down the car had stalled. I started it back up and it had a real rough idle and my check engine light was blinking( not like when you reading the codes, but more like turning a light switch off and on fast) I tried to rev it a little and it seemed to clear up. I put it in drive and it seemed to stablize. Drove the car and all seemed fine until I turned back into my drive way and it stalled again with check engine light now on. When I read the codes it gave me a code 42 and a code 43. I went ahead a did a visual check and everything looked good and tight. I cleared the codes and restarted the engine, I let it idle for about five minutes and then shut it off, when I restarted it was rough again and the blinking check engine light was back,and now it is giving me just a code 42. I have narrowed the problem down to ECM,IGNITION MODULE,ESC MODULE. Any other thoughts or ideas???

when I came down the car had stalled. I started it back up and it had a real rough idle and my check engine light was blinking( not like when you reading the codes, but more like turning a light switch off and on fast) I tried to rev it a little and it seemed to clear up. I put it in drive and it seemed to stablize. Drove the car and all seemed fine until I turned back into my drive way and it stalled again with check engine light now on. When I read the codes it gave me a code 42 and a code 43. I went ahead a did a visual check and everything looked good and tight. I cleared the codes and restarted the engine, I let it idle for about five minutes and then shut it off, when I restarted it was rough again and the blinking check engine light was back,and now it is giving me just a code 42. I have narrowed the problem down to ECM,IGNITION MODULE,ESC MODULE. Any other thoughts or ideas???

