What kind of injectors do I have?

[ROCK-N-RHONDA]

I am new to the Turbo world and need some help what type of injectors I have in my '84 T-Type.

I had my injectors pulled, cleaned and flow tested a week ago. I didnt think about looking directly at them to see if they had a number on them. So, I was wondering if any of you might know what type of injectors I actually have.

They had a Blue bottom end on them(not tops).. so are these stock?

What is the pound rating (ie. 28, or 30, etc) for these and manufactures name?

I have a picture if someone can tell from that I could email it to you. Either email me directly or let me know you email address via a reply here, okay.

They flow tested at the 65 range. What exactly is the rating called and is that a good rating?

Thanks in Advance,
Rhonda

 

[ROCK-N-RHONDA]

Anybody?

 

[Chuck Leeper]

INJ ID??

Rhonda, the 65 is most likely a flow reading in Mililiters. That corresponds to ABOUT a 28 #/hr inj, depending on what pressure they were flowed at. The standard used, pretty much all around is at 3 bars or 43.5PSI.
At 28PPh, those are stock inj's.
The cap on the bottom could be blue, yellow, brown, black... All depends on the person that did the cleaning. The cap is called a pintle cap.
HTH,

 

[ROCK-N-RHONDA]

So... if I am reading this right, I have the stock 28 lbs injectors and the flow rate is just fine the way they are now, correct?

Thanks for your help.

 

[Chuck Leeper]

28's OK??

Rhonda, if you got a flow sheet w/ the injectors, look to see if all 6 are about the same flow #. They should be within a point or two of each other to be correct.
Were the pintle caps and o'rings and filter baskets replaced when the cleaning was done??