Recent content by Maltman

If your removing the air, do you really need the heat? I don't use my car on marginal days anyway (hot or cold), so if your the same...heat won't be needed. I live in Michigan with nights that drop off pretty quick in the fall (except this year), you might run into some condensation on the...

Forgot that...errr...yeah, H&R rear sway only on mine...never tried it with the front removed and a stocker in the rear. With the mod rear, I have never noticed any problems even with aggressive driving. However, if your into taking corners, then the more sway bar the better. Straight lines...

size = too big solution = removal :D

I think you have to at least purchase a "heat only" box that come on the non-ac equiped cars.

Newer performance valve company. I purchased mine through Si Performance Stainless Valves From RPM Machine Not sure what the Si stands for. Here is the main website that I believe you could order direct from (found that out after I ordered). SI VALVES- ANTIQUE/VINTAGE ONLINE CATALOG...

Thanks Khai, I appreciate the tip and went ahead with the SI valves! Saved some cash and it sounds like a really good valve! Mark

1.500 and 1.775....looking for new valves (or at the very least "newer") for port job.

Simple request. I'm looking for F6238 and F6237. Let me know if you can help me out. Mark

Hmmm...what needs to happen to "modify" the rockers? If it is a simple bolt on, I could handle that...but any tooling is beyond my skill level. The rockers were purchased about 4 years ago...maybe 5..can't quite remember. I haven't checked prices in about 2 years, so I'm out of touch with the...

I've seen this posted... Close all the vehicle doors. Insert the ignition key into the ignition lock cylinder. Press and hold the DOOR unlock switch. While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. Release the DOOR unlock switch. The doors...

Alright...2 years off and I'm itching to get back into the car except it sits in a few different pieces right now. :( I had what felt like power loss (gradually) since it was rebuilt and didn't like what was happening, so I decided that I was going to do something about my stock heads to try...

Rochester Hills.....but getting the heck out of this concrete jungle and heading back home within the next couple months to the Grand Rapids area where my car has been resting for the past 2 years :D

Me too, me too!!!

Similar to SalvageV6's setup...but no visible cutting and you can put the original dash plate back in without anyone knowing you did anything. 2 5/8" guages throughout for me. Plate was picked up from Mark @ buickgn.com Can't remember where I got the A-pillar...but common. Anyway...

Mark (buickgn.com) sells a dash plate that works pretty slick....I put important but less used gauges over there (oil pressure, oil temp, water temp, trans temp). You can see what it looks like on my webpage in my sig under various pics. Mark