Search results

I'm sending my '87 GN in for painting and would like to know all the pieces that are satin and not gloss black, so that I can tell my painter. wheel well mouldings outside edge moulding of t-top's Unsure: Opera window edges? front, rear and middle mouldings of roof where t-tops...

I was just remounting new tires and I noticed that I can push in and pull out the passenger side axle maybe a 1/4". The drivers side has no movement whatsoever. What would allow lateral movement of the passenger side axle in the tube? Thanks in advance :)

Looking to pick up a truck for a tow vehicle. Could someone run a carfax on this please? 1FTNX20F6YEA21905 Thanks drlevine@bellsouth.net

I built a positive battery cable using 2 gauge starter cable instead of the normal 4 gauge, a 6 gauge alternator wire instead of the normal (I think) 8 gauge and a top mount terminal instead of the side mount. Everything was soldered and insulated and I think it came out looking pretty good...

Troubleshooters Please......... While driving normally in town the car simply died and would not restart. It turns over just fine and I have good fuel pressure with the pump priming when I turn the key (new walbro 340). I left the car over night and tried to start it the next day and it...

I replaced the VSS (the optical sensor and blue/green rectagular box) because my speed according to Tlink was jumping all over the place and causing the TCC to lock and unlock. Now the speed according to the computer is high as compared to actual road speed, so now the tcc is locking up early...

To get to the VSS (the green box with the led at the end of the 3 wires) in order to R&R it, do I need to remove the speedo cluster? Or can it be gotten to by going under the dash or through the radio hole in the dash. Thanks Adam

TCC locks and unlocks back and forth constantly while in 3rd at ~32-35 mph. when cruising with no acceleration. Only does this when the car is at operating temp. (not cold). In 4th and at highway speeds the tcc functions normally. I have correctly adjusted the TV cable and brake switch...

Help!! Installed (2) new switches, filter/fluid, Still got a Problem Bought 2 new switches, filter and gasket form PTS, still no luck tho. Problem is that when the tranny shifts into 3rd, it feels like it "bobbles" (for lack of a better word) back and forth between 2nd and 3rd. This...

If I have manual seat tracks, will I be able to take advantage of the 4th gen. power adjustments? If not, and I have to bolt manual seat track to the bottom, will I need to leave the switches on the left side of the seat? It will look a little on the cheesy side having a seat that goes forward...

At the 2/3 shift if I am just cruising around town the tcc will lock and unlock as if it is hunting for the right place to be. If I accelerate quickly this does not happen, also if I press the brake pedal slightly it does not happen. At highway speed the tcc works fine. Also, I have adjusted...

Could someone tell me what the bolt size is , of the bolts that hold the TV bracket to the plenum? These are the 2 little bolts on top. Thanks

Fast forward a week or so from the previous post and I did the install into the carpeted area of the door panels. They fit perfectly with the cones fitting exactly in front of the window motor. If I had used regular 4x6's the woofer would have been to far back. Here are the speakers that I...

I was at the speaker store last night and listened to some of the 4x6 plate speakers that they had. They sounded very nice, went home and measured my lower carpeted non-CS door panels. They were just over 4" wide. These plate speakers have a depth of just over 2". Would it be a problem fit...

I'm attempting to install an A pillar tach. Hookup went fine, all the connections tested out (ground, power, light) but when I tested it. Nothing happened, no needle bounce, nada. The only thing I could see was that maybe it wasn't getting a signal from the 2 wires with the green connector...

I've got a low pitched hum that seems to be coming from the front end. The faster I go the louder and higher pitched it becomes although it is never "high pitched". At around 40-45 mph I also start getting vibration that can be felt in the steering column and on the floor with your feet. The...

Is there a spacer that is supposed to be used when installing an a/c compressor? I see the first part listed as this in the gn/ttype listing of parts numbers. It lists the spacer as being .030". When I redid the a/c a spacer did not come off. Could this be why I've got a low speed...

Would these size tires be to narrow to mount on 15x8 rims? Or would they look good? Thanks

This started some time ago, I got annoyed at the car and haven't touched it for awhile. I took a look at it again today and am still stumped. A couple months ago the cooling fan stopped turning on when the...

I changed the tranny mount and must have jacked up the tranny to far b/c now the neutral safety switch is not right. The car can turnover in drive and not in neutral. Is there a way to adjust the switch back to normal? Thanks