Search results

  1. B

    WTB - Scanmaster and TV cable for trans

    Just what the title says, would prefer the G gauge ( round one I believe)
  2. B

    Anyone using a one wire alt?

    Curious as if a good one wire alt can be used on these motors with no problems. I have used them before on older chevys with great luck, just not sure if they would work the same for these. If you do used one, do you just forget about the whole plug in on the harness, or do any of those wires...
  3. B

    What do I need to do before initial start up?

    I'm hoping to give my transplant a first start and was wondering what I should set first? The car isn't ready for the road yet and I also don't have a scanmaster yet. I just want to fire it up and see that it runs, is there any kind of check and can do with the tps and such so that if it starts...
  4. B

    Is this a good setup for providing fuel?

    Ok, I have hybrid, a 63 wagon with a stock 87 GN motor and trans. I now need to supply fuel to it. I do not want to have a custom tank made and was planning on using a Aeromotive Phantom pump that installs into my stock tank. I can get one that puts out 340 or 460 lph. I can get a 1/2 inch...
  5. B

    Want to put a A/N fitting on the stock fuel rail

    HI! I'm looking to run 6A/N line up to the stock fuel rail. I have seen it before and was wondering if any one knows what the fitting would be that I need or would maybe have a part number for it? Thanks!!
  6. B

    Flex plate bolts

    I'm looking for the six bolts that attach the flex plate to the crank. That's it. I have a good flex plate, just need the bolts now.
  7. B

    Jamaicanpaul..... A+ seller

    Purchased a Power plate from him, I will say I was a little concerned that he was from Canada and didn't do PayPal, but everything went perfect and he shipped it out right after getting my check. I wouldn't worry about doing business with him at all.
  8. B

    Fat Nat..A+ seller

    I purchased a Lt1 and MAF translator from him and got it just as pictured and shipped it quick. Would do business with again anytime.
  9. B

    Simple waste gate question..... New and learning

    what happens if the car is driven with the waste gate solenoid unplugged? Everything else factory is hooked up, lines, "T" , no other boost controller. Does have a adjustable rod on the waste gate. The motor I'm looking to install was I think used this way. I have a video of it running and don't...
  10. B

    Flex plate and the mounting bolts

    Just what the title says, I'm looking for a good ( NO missing or ground down teeth ) flex plate and the six bolts to mount it to the crank. Thanks!
  11. B

    Easy vacuum line route question

    I am new to the whole turbo GN motor that I'm putting in my hybrid. I have read a lot on here and am slowly leaning and figuring this out. I'm mocking it up on my stand before I try to put it in and have some, what I think would be easy questions with the vacuum lines. First, there is a port...
  12. B

    New-B looking for " Buick Turbo for Dummies" help

    Hello! Well, I've been stalking the forum for a while now and have finally signed up. Let me start by saying I know nothing but what I've been able to get for little knowledge here. I have a 1963 Buick Wagon that I'm planning to put a '87 GN motor in that I just purchased. The car already has a...
Top