Just received my new GN today. Here's the run down of the mods:
Craig Te-67 turbo
Accufab I/C
Translator and 3.5 mass air
62 mm jay jackson tb & upper
Moroso underdrive pulleys
4in ram air
200 R4 tans. built by Rosler w/ manual valve body
Vigilate converter
mosler axles
TA girdle cover
BMR upper contole arms
Box steel lowers
Air bag on pass. side
Weld aluma stars up front 3.5
Centerline Telstars in rear w/ 275/60 tires
Drag Shocks FT. & Rear
MSD 50# inj. with Lubrant chips (street & race)
3" S.S. Houston D/P
3" ATR S.S. single shot
I need to pass VA emissions and have no cat converter. The previous owner also said the it needs to be tuned cause it runs a little rich... the fuel pressure may need to be lowered. Any suggestions on what cat I should get, how to go about getting the car tuned, and passing my emissions test?
Craig Te-67 turbo
Accufab I/C
Translator and 3.5 mass air
62 mm jay jackson tb & upper
Moroso underdrive pulleys
4in ram air
200 R4 tans. built by Rosler w/ manual valve body
Vigilate converter
mosler axles
TA girdle cover
BMR upper contole arms
Box steel lowers
Air bag on pass. side
Weld aluma stars up front 3.5
Centerline Telstars in rear w/ 275/60 tires
Drag Shocks FT. & Rear
MSD 50# inj. with Lubrant chips (street & race)
3" S.S. Houston D/P
3" ATR S.S. single shot
I need to pass VA emissions and have no cat converter. The previous owner also said the it needs to be tuned cause it runs a little rich... the fuel pressure may need to be lowered. Any suggestions on what cat I should get, how to go about getting the car tuned, and passing my emissions test?