So oddly enough, I really don’t know what or how I fixed this, I re flashed it and that did not help.
I just went back through everything and wiggled / sured up connections / changed a spade connector and apparently there must’ve been some kind of contact issue because after I did that...
Pretty sure I re-flashed it about a year -2 ago, but let me verify what version I’m running hopefully that’s it
Thanks!
Sent from my iPhone using Tapatalk
99.9% sure it’s converter ( you know how noises can “bounce” though). I have not disconnected it yet, will I have to get it back over to my buddies house with a lift. Will report back.
Thx
Sent from my iPhone using Tapatalk
Installed today. All the wiring is correct. Connections are good. I have a power longer, comms wired to port 7 SCM, Power is good at 12 V, ground secure to frame bolt.
When I turn the key to the on position, It boots up says “connected” and shows random readings ( False albeit - such as the...
Any ideas on this noise? It is a single disk circle D 9” pro billet.
Mainly audible @ idle/neutral. Goes away under load ( Or at least reduces greatly under load )
I know I’m probably going to have to pull it, I’m just curious if anyone out there has been down this road and had this noise...
If ur looking for another option, I have a Gen2 translator and adapter for ECM....since u mentioned the “old way” etc
U can tune from gen2, also....
$200 shipped
Sent from my iPhone using Tapatalk
Everything works as it should. Changing my set up. Don’t want to separate. Includes what’s in the picture. PM for my PayPal (friends / family).
$240, includes shipping (USPS)
Sent from my iPhone using Tapatalk