cronanzone
Member
- Joined
- May 7, 2018
- Messages
- 72
Installed today. All the wiring is correct. Connections are good. I have a power longer, comms wired to port 7 SCM, Power is good at 12 V, ground secure to frame bolt.
When I turn the key to the on position, It boots up says “connected” and shows random readings ( False albeit - such as the speed was jumping around etc)
When I start it up, It again says “connected”, However, all readings are reading zero.
It does not say “no data”, But instead I just get zeros across the board....
Any ideas where I should start running down the rabbit hole?
TIA
Sent from my iPhone using Tapatalk
When I turn the key to the on position, It boots up says “connected” and shows random readings ( False albeit - such as the speed was jumping around etc)
When I start it up, It again says “connected”, However, all readings are reading zero.
It does not say “no data”, But instead I just get zeros across the board....
Any ideas where I should start running down the rabbit hole?
TIA
Sent from my iPhone using Tapatalk