Recent content by DARTHV6

  1. DARTHV6

    Mechanical Water sensor size and thread

    Got it. Thanks!
  2. DARTHV6

    Mechanical Water sensor size and thread

    That’s a good looking motor! Ok, So is this where the mechanical water temperature gage goes? On the drivers side?
  3. DARTHV6

    Mechanical Water sensor size and thread

    Is this the passenger side sensor for the idiot light? I was thinking I was to replace the sensor on the drivers side With the mechanical sensor?
  4. DARTHV6

    Mechanical Water sensor size and thread

    Like to see it
  5. DARTHV6

    Mechanical Water sensor size and thread

    Thank you!
  6. DARTHV6

    Mechanical Water sensor size and thread

    Still helping my friend with his 1937 Chevy Deluxe with a GN drivetrain. He bought a Speedway mechanical temperature and oil gage. I don’t know anything about mechanical gages but I’ll put it in for him. The port adapter that came with the gage is too big. What’s the size and thread of the...
  7. DARTHV6

    Looking for help to start this engine build

    I’ll find one and see if I can match it up. Lot mor steps than I thought! Thanks!
  8. DARTHV6

    Looking for help to start this engine build

    I’m stuck here. (Might re-post if needed) Where do the key switch wires connect? Thanks, Art
  9. DARTHV6

    87 or 86 fuse box equvelent

    Thank you…this is good information. I‘m helping out a good friend so I gave him a GN motor and transmission. We got it in and it ran with minimum wires. His wife will not let him race it. The car has a S-10 steering wheel. I wasn’t supposed to be the wiring guy but after his two brothers died on...
  10. DARTHV6

    87 or 86 fuse box equvelent

    I’m placing a 1986 GN engine and transmission in a 1938 Chevy Deluxe. Wish me luck! I have a full engine harness but I can’t find a 86/87 fuse box. Does anyone know of an equivalent, or other G Body fuse box? Thanks for the help. Art
  11. DARTHV6

    Need a suggestion for rear speakers 1987 GN

    Those look nice! Thanks for responding
  12. DARTHV6

    Looking for help to start this engine build

    Ya! I have my work cur out for me. I have the original full GN engine harness and a lot of patience so we will see!
  13. DARTHV6

    Looking for help to start this engine build

    I agree! Back story, my friend was to build this car with his Brothers. They died on the same day last year and he hasn’t worked on it since. Here I am trying to get it started to give him some hope. Wish me luck!!
  14. DARTHV6

    Looking for help to start this engine build

    Good information, thank you. Just to start the car, should I put a fuse on the 4 wires leading to C100 not supported by the fuse box, before or after I connect it to the C100? Might put a switch on the fuel pump wire and the ECM in case I do something dumb? Thanks, Art
  15. DARTHV6

    Looking for help to start this engine build

    Kinda long request but bare with me. I’m helping a friend/neighbor with a 1937 Chevy Deluxe that has my GN motor and transmission in it. Long story but we tried three different S-10 motors that were junk so I gave him my old one. I just want to start the engine in the car to give him some hope...
Top