Recent content by Hotshoe

I am preparing to install my o-ringed stock big valve heads. I am using Fel Pro o-ring gaskets and ARP studs. Anyone have any advice on the whats best to seal for coolant and any other potential weak areas? Would the G.E. sealant be a good idea? Anyone that has had good success with the the...

Sorry For the double post.

Parts I'll take the HD actuator. GOT PAYPAL? :cool: PM me. Thanks, Hotshoe

translator is that a t-plus? I'd take it if it's a translator plus.

Anyone? Pm or e-mail me with details and price.

Need slightly used heavy duty actuator and an RJC boost controler at a rightious price ;) .

The only thing that looks way too small is the waste gate hole.

I see you neglected the TPS sensor. I've had a bad TPS create the same symptoms you have discribed. To test if if you aren't familiar with a OTC 4000E or one of the other laptop diagnostic systems. The old multimeter works fine for a quick test. This is the way I check to see if it's...

Just got my 70 yesterday and agree with Donnie the thing is huge. I immediately broke out the aluminum polish and hit the compressor side til the shine was blinding. Sure takes the pain of not being at the Buick Nationals away a little bit. I'm in the same boat as Donnie as I have a long...

Is it a sequential DFI? Wiring harness? WIdeband? Need sensors or will the stock buick ones work? How old is the unit? EDIS compatible? Thanks

They're Iron heads these were done before they started making the aluminum heads. Anyone have a good deal for ported and polished set of irons? :rolleyes:

After ripping off a lot of buick guys the word got out and nobody reomends this guy for changing a spark plug in a lawn mower. The guy started out doing good work but probably thought it wasen't creating enough cashflow so he started to make it the old fahioned way he stole it. One of the guys...

My car has been hibernating in my garage for the last 8 years having only 10k miles on the last rebuild before the oil pressure went down to 5 lbs. So After a healthy tax refund I decided to rebuild it for the third time, but this time i'm doing it myself. After removing the intake I discovered...

So far the TA64 is the biggest stock appearing turbo they make but you might be able to get it in a GT compressor wheel good for mid to low ten's.

I'm looking into a few with Jack Cotton he's got competitive prices for turbo's as of late (will be talking to him today as a matter of fact). If this is a car you want driven mainley on the street the biggest turbo with enough grunt to almost get to the 9's with some primo tuning and lots of...