The reason I’m putting this post in the general discussion part is I’m not sure if it’s a transmission issue , computer issue or a chip issue. Last week while doing a shake down drive my car would stall when coming to a complete stop. This didn’t happen right away but only after about 8-10...
I’m pretty sure it’s not the original valve body. There’s a bolt that has a stack of washers. It had to be replaced prior to 1994 since I’ve owned it since then.
Thank you. New solenoid will be here Wednesday. It looks like I’m missing the 3rd gear switch altogether the valve body looks like it may have been replaced way back in the early 90s
Car dies when I come to complete stop. I have 4 wires coming from the connector on the drivers side trans case. 2 go to the passenger front solenoid 1 goes to pressure switch on passenger side rear. The other one was not connected to anything and I cannot see anywhere it would connect to. So my...
Thank you. I want to stay around stock for now. I haven’t driven the car for the last 15-18 years. I want to enjoy it for a while before I do any more upgrade power wise. The upgrades I have done have been necessary to get it back running so since I was replacing I might as well upgrade. I’m...
Looking for a stock or next to stock turbo. Currently have stock turbo from 1986 and I can move shaft 1/4” side to side and I am getting a good amount of smoke out the exhaust. Appears to be no oil in the radiator and no water in the oil. I do google searches for stock replacement turbos but it...
when i installed new cam sensor cap the directions say to turn sensor until LED comes on. When i did this the LED was dimmly on but when i turned it it went brighter. so i locked it down at that point.should the LED been off? if so what would cause it. I reached out to Caspers on this aswell but...
Is there a way to test that or just replace? I’m not against replacing it. What would be a good replacement? Should I do away with stock air box at the same time?
Yes Led cap. It has an adjustment slot in the cap. Little or no improvement if I tweak it. Is it possible I didn’t reinstall it correctly. Or is it only that it’s install correctly or 180 off. Could be wires I got a cheap set from autozone just to see if it improved it any.