Recent content by nxinehp

Th200 4r 3rd gear port where is third gear pressure port in a TH200 4r tranny? Are there any picture or diagrams on the net?:confused:

I spent a long time banging on the rear drums to remove them. After getting them off I noticed a spot on the back of the plate that holds the brake/shoes that seem to be a covered slot that can be used to adjust the brakes to make it easier to remove the drums. Can I knock or punch out the...

Thank you, I really needed the info. I spent a lot of hours searching for the items. Point of info is in reading the tread i came across the CK site once before. It does not list any of the items talked about. So using your directions tbat this is the spot, I took a chance and call at this late...

Junior Member Also, where can the connector, wire, & pressure switch be purchased from?

Junior Member Thanks! I feel much better now. However, I do not know what an 1/8 NPT tap is, please explain. Do have any ref numbers & names for the parts I am to purchase?

I just installed the tranny. Does this mean I have to pull the tranny out to change it from a 3 plug connector to the 4 plug connector using the suggested kit?

I purchased the car without a trans in it. The trans model year is 1986. Is there a good supplier for the shift kit, and servo you are speaking of? I tried a GM dealership parts dept. and they told me they needed the VIN # of the car in order to help me. I tried to tell them that the trans was...

Thank you Mikestertwo i got it done.

Thanks! I new at this any details on process, i.e. do I spray the whole can down the ? line for internal cleaning?

Is there a shade tree method for cleaning the trans lines?

Thank you for the reply. My 87 GN is a bone stock car and will stay stock. I want to become a good shade tree tuner (I will explain this later). Please point me to some instructions, i.e. swap out connector and add wire and pressure switch for third gear.

I am a true blue newbe (for the sake of brevity I will leave it at that!) and I purchased a KZF 200-4r tranny. Installed it only to find out that the trans plug in my 87 GN has 4 wires the tranny takes a three wire plug. Can this be corrected or do I go back to the seller and cry foul, because...

Is their an after market tube & dip stick that can be installed that does not require removing the trans.?

I have been out of commission for the last few weeks, but I am back and ready to go. I am still installing my trans. my current problem is that I cannot figure out the dip stick installation, i.e., i got it touching the trans but I cannot get it to go into the hole and line up with the top bolt...

I had the same identicle problem. I tried using several diff things that did not work. Found a fuseable link (work great now!) from a small auto parts store in Allen Park, MI, I cannot remember the name. Dealerships and large auto supplyers did not have it in the metro Detroit area.